– 98 –
No. Item Setting range Edit unit
Needle stop position is set.
--- ---
UP position
Upper dead point
Thread trimming can be prohibited.
--- ---
Normal
Thread trimming
prohibited
Route of return to origin by return to origin button can be selected.
--- ---
Linear return
Reverse return of
pattern
Origin retrieval
/
Sewing start point
Bobbin winding speed can be set.
800 to 2000 100 sti/min
Motion method of wiper can be selected.
--- ---
Invalid
Magnet typewiper
Unit of sewing shape size change can be selected.
--- ---
%input Actual size input
Thread tension output time when setting
thread tension can be set.
0 to 20 1
Bend position of thread clamp is selected.
0 : S type
1 : H type thin thread (#50 to #8)
2 : H type intermediate
3 : H type thick thread (#5 to #2)
---
---
Thread clamp and thread clamp position selection
--- ---
Front position Rear position
Thread breakage detection selection
--- ---
Thread breakage
detection invalid
Thread breakage
detection valid
Number of invalid stitches at the start
of sewing of thread breakage detection
0 to 15
stitches
1 stitch
Number of invalid stitches during sewing
of thread breakage detection
0 to 15
stitches
1 stitch
To Next Page
Loading...
