ā 99 ā
No. Item Setting range Edit unit
Feeding frame control : pedal open/close
Operation order of feeding frame by pedal
operation at the normal time is set.
0 to 99 1
(At the time of control by motor)
0 : Solid presser
1 : Solid presser 2-step stroke (Lowering again with presser switch)
2 :
Solid presser 2-step stroke (Down to the bottom + start with start switch)
3 : Solid presser 2-step stroke
(Intermediate
/
down to bottom
/
going up with presser SW)
4 to 99 : Solid presser
(At the time of control by air)
0 : Solid presser
1 : Right/left separated presser (Without priority of right/left)
2 : Right/left separated presser (In the order of right to left)
3 : Right/left separated presser (In the order of left to right)
4 to 7 : Special type (*1)
8 : Solid presser
9 : Solid presser 2-step stroke
10 :
Right/left separated presser 2-step stroke (Without right/left separation)
11 :
Right/left separated presser 2-step stroke (Order of right to left)
12 :
Right/left separated presser 2-step stroke (Order of left to right)
13 to 99 : Solid presser
*1 : When using these items, refer to Engineer's Manual.
Feeding frame control : midway stop time open/close
Operation order of feeding frame by pedal operation
when lifting the feeding frame by the temporary
stop command in the pattern data is set.
0 to 99 1
(At the time of control by motor)
0 : Solid presser
1 : Solid presser 2-step stroke (Down to bottom with presser switch)
2 :
Solid presser 2-step stroke (Down to the bottom + start with start switch)
3 : Solid presser 2-step stroke
(Intermediate
/
down to bottom
/
going up with presser SW)
4 to 99 : Solid presser
(At the time of control by air)
0 : Solid presser
1 : Right/left separated presser (Without priority of right/left)
2 : Right/left separated presser (In the order of right to left)
3 : Right/left separated presser (In the order of left to right)
4 to 7 : Special type (*1)
8 : Solid presser
9 : Solid presser 2-step stroke
10 :
Right/left separated presser 2-step stroke (Without right/left separation)
11 :
Right/left separated presser 2-step stroke (Order of right to left)
12 :
Right/left separated presser 2-step stroke (Order of left to right)
13 to 99 : Solid presser
*1 : When using these items, refer to Engineer's Manual.
To Next Page
Loading...
