JUKI IP-420 - 4. Error Code List

– 100 –
No. Item Setting range Edit unit
Pedal SW1 with/without latch
--- ---
Without With
Pedal SW2 with/without latch
--- ---
Without
With
Pedal SW3 with/without latch
--- ---
Without With
Pedal SW4 with/without latch
--- ---
Without With
Enlarging/reducing function mode
--- ---
Prohibited Increasing/decreasing
number of stitches
(Pitch is xed.)
Increasing/decreasing
pitch (Number of
stitches is xed.)
Jog move function mode
--- ---
Prohibited
Parallel move
2nd origin specied later
Retainer compensation motion : selection of motion
--- ---
Without motion
With motion
Selection of needle upper dead point at the time of origin
retrieval/return to origin
--- ---
Without With
Temporary stop : thread trimming operation
--- ---
Automatic thread
trimming
Manual (Thread trimming by
turning Stop SW ON again)
Main motor X/Y feed synchronized control : speed/pitch
--- ---
2800 sti/min/
4. 0mm
2200 sti/min/
4. 0mm
1800 sti/min/
4. 0mm
1400 sti/min/
4. 0mm