– 87 –
(4) Continuous operation
After the setting of continuous operation, the condition moves to the continuous operation mode.
Turn OFF the power to close the continuous operation mode.
1) Press READY key
❷
to bring the aging in
the enabled state. Then, display the check pro-
gram screen.
Press ITEM SELECT key
❻
to select the
setting item.
Setting item is displayed in section
A
.
Press DATA CHANGE key
❼
to enter a
value of setting item that is selected.
Setting value is displayed in section
B
.
2) Select the pattern No. that will perform the con-
tinuous operation, change over to the sewing
screen. Turn ON the start switch, start the contin-
uous operation.
After the completion of sewing, origin retrieval of
the X/Y/work clamp foot/thread trimmer/needle
thread clamp motor is conducted if "origin retriev-
al enabled" has been set. In this case, automatic
sewing operation is restarted after the lapse of the
rest time specied.
To stop continuous operation, turn ON the Start
SW during the rest time. "E050 Temporary stop
error" is displayed and operation is suspended.
Setting items are as follows.
3) When RETURN key
❾
is pressed, the
screen returns to the check program screen.
Setting items
No. Setting items Pictogram Setting items
1 Rest time 0 to 9900 ms (Initial value : 2000 ms)
2 Origin retrieval enable/disable
setting at the end of sewing
0 : Disable (Initial value)
1 : Every 100 sewing cycles
2 : Every sewing cycle
❻ ❼
❾
A
B
❷
(Remarks) The description only uses the panel
diagram of the standard specication.
(Remarks) The description only uses the panel
diagram of the standard specication.
To Next Page
Loading...
Need help?
General
