JUKI LK-1900B series - 13) a Djustment Of The Height Of The Work Clamp Foot; 14) a Djustment Of The Thread Trimmer Sensor

– 24 –
(13) Adjustment of the height of the work clamp foot
WARNING :
As the work is performed while the power is ON, never touch the switches other than the necessary
one so as to prevent accidents caused by the malfunction of switches.
Standard adjustment
(14) Adjustment of the thread trimmer sensor
WARNING :
As the work is performed while the power is ON, never touch the switches other than the necessary
one so as to prevent accidents caused by the malfunction of switches.
Standard adjustment
Afterthecompletionoforiginretrievalinthecheckprogram06(StartSwitchON),pressingtheminuskey
oftheDATACHANGEkey
❼
intherangeof6to8timeswillturnoffthethreadtrimmersensor.(The
display
❶
at the operation panel " " → " ")
Max. 17 mm
(LK-1900BB : Max. 14 mm)
❼❶
(Remarks) The description only uses the panel
diagram of the standard specication.