– 113 –
(3) Greasing parts
1. When the parts for greasing and grease sealing-in are disassembled and the operational frequency seems
to be higher than usual around these parts, grease should be replenished once in one to two years.
2. Recommendable grease
This sewing machine uses three types of grease as specied below. The recommendable brands of
grease are listed in "10.-(4) Parts to which grease is applied." According to this information, replenish the
most applicable grease to these parts.
* Use
❶
Lithium Type Consistency No. 2 for the parts where "Grease" is simply specied in
"10.-(4) Parts to which grease is applied
".
❶
Penetration No. 2 lithium grease (Grease)
This type of grease is used in general sliding parts.
Maker name Brand name
Esso Barch L1002
Shell Albania EP-2
JX Holdings, Inc. Epinok AP2
Lisonix 2
Idemitsu Kosan Co., Ltd. Coronex 2
❷
Unirex N3 (Grease D) ······· Used for the feeding gear block.
· 10g tube JUKI Part No.: 13525506
❸
JUKI Grease A ······· Used for high-speed sliding parts and their peripheral parts.
Used, in particular, for the specic areas with highly loaded parts.
Important: this grease must be replenished at the specied intervals of period, according to "10.-(5)
Grease-up procedures for the specied position."
· 10g tube JUKI Part No.: 40006323
· 100g tube JUKI Part No.: 23640204
3. Method of greasing
If no grease pump is available, ll a plastic oilcan with grease. Otherwise, an injector without a needle can
be conveniently used.
· An injector to be used exclusively for coating / JUKI part No.: GDS01007000
To Next Page
Loading...
Need help?
General
