JUKI LK-1900B series Engineer's Manual

– 123 –
11. Error list
Error
code
Indica-
tion
Description of error Corrective measure Remarks
E007
Machine lock error
The main shaft of the sewing ma-
chine does not rotate due to some
troubles.
Turn OFF the power switch
and remove the cause of
troubles.
E010
Pattern No. error
Back-uped pattern No. has not
been registered in the data ROM,
or it is set to readout inoperative.
Pattern No. is set to “0”.
Press the reset switch and
check the pattern No.
Check the contents of
memory switch No. 201.
E011
External media not inserted
USB thumb drive is not inserted.
Re-operation is enabled
after resetting.
E012
Read error, external
Data cannot be read from the USB
thumb drive.
Re-operation is enabled
after resetting.
E013
Write error, external
Data cannot be written on the USB
thumb drive.
Re-operation is enabled
after resetting.
E014
Write-protect
USB thumb drive is write-protected.
Re-operation is enabled
after resetting.
E015
Format error
USB thumb drive cannot be format-
ted.
Re-operation is enabled
after resetting.
E016
External media capacity over
Memory capacity of the USB thumb
drive to write pattern data is not suf-
cient.
Re-operation is enabled
after resetting.
E017
Machine memory capacity over
Memory capacity of the sewing
machine to write pattern data is not
sufcient.
Re-operation is enabled
after resetting.
E019
File size over
The pattern data to be read from
the USB thumb drive is too large.
(Max.: Approximately 20000 stitch-
es)
Re-operation is enabled
after resetting.
E024
Pattern data size over
The pattern data to be written on
the sewing machine memory is too
large. (Max.: Approximately 20000
stitches)
Re-operation is enabled
after resetting.
E030
Needle bar position error
Needle bar is not in the specied
position.
Turn the hand pulley to
return the needle bar to its
specied position.

JUKI LK-1900B series Specifications

General

Brand	JUKI
Model	LK-1900B series
Category	Sewing Machine
Language	English