JUKI LK-1900B series Engineer's Manual

– 124 –
Error
code
Indica-
tion
Description of error Corrective measure Remarks
E040
Sewing area over
The sewing area is beyond the limit.
Press the reset key and
check the pattern and X/Y
scale rate.
This error is output
when max. sewing
area, 30 x 40 is
over. Interference
of the work clamp
foot with needle is
not protected.
E043
Enlargement error
The sewing pitch is beyond 10 mm.
Press the reset key and
check the pattern and X/Y
scale rate.
E045
Pattern data error
The pattern data cannot be adopt-
ed.
Re-operation is enabled
after resetting.
E050
Temporary stop
Temporary stop by operating the
reset switch while the sewing ma-
chine is running. (Refer to memory
switch No. 31.)
Re-start or return-to-origin
after thread trimming by
means of the reset switch
(For further details, refer to
"I.6-4. How to use the tem-
porary stop" in the Instruc-
tion Manual.)
E061
Memory switch data error
Memory switch data is broken or
revision is old.
Re-operation is enabled
after resetting.
E063
Machine head identication error
The type of machine head and the
type of control box do not match.
Turn the power OFF and
contact JUKI or your dis-
tributor.
E204
Connection alert for the USB
thumb drive which is used for
sewing
Sewing has been carried out by 10
or more times with the USB thumb
drive inserted in the USB port.
Re-operation is enabled
after resetting.
E220
Grease replenishing time infor-
mation
Information as to the time of replen-
ishing the designated places with
grease.
Replenish the designated
places with grease and
set memory switch U245
to “0” with the RESET
key. Error can be released
with the RESET key when
immediate replenishing
with grease cannot be
performed during sewing
operation.
Refer to "10.-(5)
Grease-up proce-
dures for the spec-
ied position".
E221
Grease replenishing warning error
Sewing machine has stopped since
the time of replenishing the desig-
nated places with grease has come.
Immediately perform re-
plenishing with grease and
set memory switch U245 to
“0” with the RESET key.
Refer to "10.-(5)
Grease-up proce-
dures for the spec-
ied position".
E302
Head tilt error
Head tilt detection switch is turned
OFF.
The sewing machine
cannot be operated with
the head tilted. Return the
sewing machine head to its
proper position.

JUKI LK-1900B series Specifications

General

Brand	JUKI
Model	LK-1900B series
Category	Sewing Machine
Language	English