JUKI LK-1900B series - Registering an NFC Terminal

– 70 –
14 Irregular operation setting
15 Memory switch 2
16 NFC registration ON/OFF
17 NFC registration
❺
❺
❶
❷
❾
❾
❺
❺ ❶
A
(7) Registering an NFC terminal
You can put restrictions so that only a registered NFC terminal can use the NFC function.
①
Selecting the Enabled or Disabled state of a restriction in using an NFC terminal
1. Hold down the
❾
for six seconds
on the sewing screen to display the ser-
viceperson level 2 mode screen.
2. Press the
❶
to select "16.
NFC registration ON/OFF," and press
the
❺
to display the selection
screen for the Enabled or Disabled re-
striction of an NFC terminal.
3. After pressing the
❷
, you can
change the state of Enabled (ON) or
Disabled (OFF) of a restriction.
4. Press the
❺
to x the settings, and
press the
❻
to cancel it and then
the current screen returns to the last
(rst previous) screen.
②
Registering an NFC terminal
1. Select the "17. NFC registration" on the
screen for a maintenance engineer or
the serviceperson level 2 mode screen,
and press the
❺
to display the
NFC terminal registration screen.
2. Press the
❶
to select the NFC
terminal new registration pictogram
A
,
and press the
❺
to display the
NFC guide message screen.
13 Check program
14 Irregular operation setting
15 Memory switch 2
16 NFC registration ON/OFF