6. (Optional) Configure the name of the router. If the name includes spaces, enclose the name in quotation
marks (“ ”).
[edit]
root@# set system host-name host-name
7. Configure the default gateway.
[edit]
root@# set routing-options static route default next-hop address
8. Configure the IP address and prefix length for the router’s management interface.
[edit]
root@# set interfaces em0 unit 0 family inet address address/prefix-length
CAUTION: Although you can use the CLI to configure two management Ethernet
interfaces within the same subnet, only one interface is usable and supported.
NOTE: The management port (MGMT) is located on the management panel of the
ACX5400 router.
9. (Optional) Configure the static routes to remote prefixes with access to the management port.
[edit]
root@# set routing-options static route remote-prefix next-hop destination-ip retain no-readvertise
10. Enable the Telnet service.
[edit]
root@# set system services telnet
NOTE: When Telnet is enabled, you cannot log in to a router through Telnet by using
root credentials. Root login is allowed only for SSH access.
11. Commit the configuration to activate it on the router.
[edit]
110
To Next Page
Loading...
