EasyManuals Logo

Juniper EX3300 Hardware Guide

Juniper EX3300
354 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #301 background imageLoading...
Page #301 background image
Table 48: show interfaces ge- Output Fields (continued)
Level of OutputField DescriptionField Name
extensiveInformation about link autonegotiation:
Negotiation status:
CompleteThe autonegotiation process between the local and remote
Ethernet interfaces was successful.
Incomplete—Remote Ethernet interface has the speed or link mode
configured or does not perform autonegotiation.
No autonegotiation—Local Ethernet interface has autonegotiation disabled
and the link mode and speed are manually configured.
Link partner—Information from the link partner:
Link mode—Depending on the capability of the attached Ethernet device,
either Full-duplex or Half-duplex. If the link mode of the remote device
cannot be determined, the value is Unknown.
Flow controlTypes of flow control supported by the remote Ethernet
device. For Gigabit Ethernet interfaces, the types are: Symmetric (link
partner supports PAUSE on receive and transmit); Asymmetric (link partner
supports PAUSE on transmit); and Symmetric/Asymmetric (link partner
supports PAUSE on both receive and transmit or PAUSE only on receive).
Remote fault—Remote fault information from the link partner—Failure
indicates a receive link error. OK indicates that the link partner is receiving.
Negotiation error indicates a negotiation error. Offline indicates that the
link partner is going offline.
Link partner speed—Speed of the link partner.
Local resolution—Resolution of the autonegotiation process on the local
interface:
Flow controlType of flow control that is used by the local interface. For
Gigabit Ethernet interfaces, the types are: Symmetric (link partner supports
PAUSE on receive and transmit); Asymmetric (link partner supports PAUSE
on transmit); and Symmetric/Asymmetric (link partner supports PAUSE
on both receive and transmit or PAUSE only on receive).
Link mode—Link mode of local interface: either Full-duplex or Half-duplex.
Displayed when Negotiation status is Incomplete.
Local link speed—Speed of the local interface. Displayed when Negotiation
status is Incomplete.
Remote fault—Remote fault information. Link OK (no error detected on
receive), Offline (local interface is offline), and Link Failure (link error
detected on receive).
Autonegotiation
information
extensiveInformation about the configuration of the Packet Forwarding Engine:
Destination slot—FPC slot number:
On standalone switches with built-in interfaces, the slot number refers to
the switch itself and is always 0.
On Virtual Chassis composed of switches with built-in interfaces, the slot
number refers to the member ID of the switch.
On switches with line cards or on Virtual Chassis composed of switches
with line cards, the slot number refers to the line card slot number on the
switch or Virtual Chassis.
PacketForwarding
Engine
configuration
Logical Interface
281Copyright © 2015, Juniper Networks, Inc.
Chapter 5: Operational Commands

Table of Contents

Other manuals for Juniper EX3300

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper EX3300 and is the answer not in the manual?

Juniper EX3300 Specifications

General IconGeneral
Ethernet LANYes
Authentication methodRADIUS, TACACS+
Connectivity technologyWired
Ethernet interface typeGigabit Ethernet
Number of VLANs4096
Networking standardsIEEE 802.1ab, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ad, IEEE 802.3x, IEEE 802.3z
Ethernet LAN data rates10, 100, 1000 Mbit/s
Copper ethernet cabling technology1000BASE-T, 100BASE-TX, 10BASE-T
Console port-
ExpressCard slotNo
Fiber ports quantity4
USB 2.0 ports quantity0
Basic switching RJ-45 Ethernet ports quantity48
Throughput130 Mpps
Number of queues8
MAC address table16000 entries
Maximum data transfer rate176 Gbit/s
Supported data transfer rates10, 100, 1000Mbps
Switch typeManaged
Switch layerL2
Security algorithmsSSH-2
Power sourceAC
AC input voltage100 - 240 V
Power consumption (typical)100 W
Form factor1U
Product colorBlack
Flash memory1024 MB
Processor frequency1000 MHz
Compatible operating systemsJunos
Operating altitude0 - 3049 m
Non-operating altitude0 - 4877 m
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)0 - 45 °C
Storage relative humidity (H-H)0 - 95 %
Operating relative humidity (H-H)10 - 85 %
Supported network protocolsIPv6
Weight and Dimensions IconWeight and Dimensions
Depth310 mm
Width437 mm
Height44 mm
Weight4900 g

Related product manuals