CHAPTER 2
Configuration Tasks
•
Configuring Gigabit Ethernet Interfaces (CLI Procedure) on page 32
•
Configuring Gigabit Ethernet Interfaces (J-Web Procedure) on page 35
•
Port Role Configuration with the J-Web Interface (with CLI References) on page 41
•
Adding a Logical Unit Description to the Configuration on page 45
•
Disabling a Physical Interface on page 45
•
Disabling a Logical Interface on page 47
•
Configuring Flow Control on page 47
•
Configuring the Interface Address on page 48
•
Configuring the Interface Bandwidth on page 52
•
Configuring the Media MTU on page 53
•
Setting the Protocol MTU on page 65
•
Interface Ranges on page 66
•
Configuring Accounting for the Physical Interface on page 74
•
Configuring Accounting for the Logical Interface on page 76
•
Configuring Ethernet Loopback Capability on page 77
•
Configuring Gratuitous ARP on page 78
•
Configuring Static ARP Table Entries on page 79
•
Disabling the Transmission of Redirect Messages on an Interface on page 80
•
Configuring Restricted and Unrestricted Proxy ARP on page 80
•
Enabling or Disabling SNMP Notifications on Logical Interfaces on page 81
•
Configuring Aggregated Ethernet Links (CLI Procedure) on page 82
•
Configuring Aggregated Ethernet Interfaces (J-Web Procedure) on page 83
•
Configuring Aggregated Ethernet LACP (CLI Procedure) on page 86
•
Configuring LACP Link Protection of Aggregated Ethernet Interfaces (CLI
Procedure) on page 87
•
Configuring Aggregated Ethernet Link Protection on page 89
•
Configuring Aggregated Ethernet Link Speed on page 90
•
Configuring Aggregated Ethernet Minimum Links on page 92
31Copyright © 2015, Juniper Networks, Inc.