Juniper EX3300 Hardware Guide

show interfaces xe-
Syntax show interfaces xe-fpc/pic/port
<brief | detail | extensive | terse>
<media>
<statistics>
Release Information Command introduced in Junos OS Release 9.0 for EX Series switches.
Description Display status information about the specified 10-Gigabit Ethernet interface.
NOTE: You must have a transceiver plugged into an SFP+ or an XFP port
before information about the interface can be displayed.
NOTE: On an EX Series switch, the traffic statistics for a LAG might vary
slightly from the cumulative traffic statistics of the member interfaces of the
LAG. This difference is more likely to be seen when the traffic is bursty in
nature, and because the statistics are not fetched from the LAG and the
members in the same instant. For accurate traffic statistics for a LAG, use
the aggregated Ethernet counters.
Options xe-fpc/pic/port —Display standard information about the specified 10-Gigabit Ethernet
interface.
brief | detail | extensive | terse—(Optional) Display the specified level of output.
media—(Optional) Display media-specific information about network interfaces. For
10-Gigabit Ethernet interfaces, using the media option does not provide you with
new or additional information. The output is the same as when the media option is
not used.
statistics—(Optional) Display static interface statistics. For 10-Gigabit Ethernet interfaces,
using the statistics option does not provide you with new or additional information.
The output is the same as when the statistics option is not used.
Required Privilege
Level
view
Related
Documentation
Monitoring Interface Status and Traffic on page 233•
• Troubleshooting Network Interfaces on EX3200 Switches
• Troubleshooting Network Interfaces on EX4200 Switches
• Troubleshooting an Aggregated Ethernet Interface on page 329
• Junos OS Ethernet Interfaces Configuration Guide
307Copyright © 2015, Juniper Networks, Inc.
Chapter 5: Operational Commands

Juniper EX3300 Specifications

General

Ethernet LAN	Yes
Authentication method	RADIUS, TACACS+
Connectivity technology	Wired
Ethernet interface type	Gigabit Ethernet
Number of VLANs	4096
Networking standards	IEEE 802.1ab, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ad, IEEE 802.3x, IEEE 802.3z
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Copper ethernet cabling technology	1000BASE-T, 100BASE-TX, 10BASE-T
Console port	-
ExpressCard slot	No
Fiber ports quantity	4
USB 2.0 ports quantity	0
Basic switching RJ-45 Ethernet ports quantity	48
Throughput	130 Mpps
Number of queues	8
MAC address table	16000 entries
Maximum data transfer rate	176 Gbit/s
Supported data transfer rates	10, 100, 1000Mbps
Switch type	Managed
Switch layer	L2
Security algorithms	SSH-2
Power source	AC
AC input voltage	100 - 240 V
Power consumption (typical)	100 W
Form factor	1U
Product color	Black
Flash memory	1024 MB
Processor frequency	1000 MHz
Compatible operating systems	Junos
Operating altitude	0 - 3049 m
Non-operating altitude	0 - 4877 m
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	10 - 85 %
Supported network protocols	IPv6

Weight and Dimensions

Depth	310 mm
Width	437 mm
Height	44 mm
Weight	4900 g