Juniper EX3300 Hardware Guide

List of Sample Output show interfaces xe-4/1/0 on page 316
show interfaces xe-0/1/0 brief on page 317
show interfaces xe-4/1/0 detail on page 317
show interfaces xe-6/0/39 extensive on page 318
Output Fields Table 52 on page 308 lists the output fields for the show interfaces xe- command. Output
fields are listed in the approximate order in which they appear.
Table 52: show interfaces xe- Output Fields
Level of OutputField DescriptionField Name
Fields for the Terse Output Level Only
terseName of the physical or logical interface.Interface
terseAdministrative state of the interface.Admin
terseState of the physical link.Link
terseProtocol family configured on the logical interface.Proto
terseLocal IP address of the logical interface.Local
terseRemote IP address of the logical interface.Remote
Fields for the Physical Interface
brief
detail
extensive
none
Name of the physical interface.Physical interface
brief
detail
extensive
none
State of the interface. Can be one of the following:
• Administratively down, Physical link is Down—The interface is turned off, and
the physical link is inoperable and cannot pass packets even when it is
enabled.
• Administratively down, Physical link is Up—The interface is turned off, but the
physical link is operational and can pass packets when it is enabled.
• Enabled, Physical link is Down—The interface is turned on, but the physical
link is inoperable and cannot pass packets.
• Enabled, Physical link is Up—The interface is turned on, and the physical link
is operational and can pass packets.
Enabled
detail
extensive
none
Index number of the physical interface, which reflects its initialization sequence.Interface index
detail
extensive
none
SNMP index number for the physical interface.SNMP ifIndex
detail
extensive
Unique number for use by Juniper Networks technical support only.Generation
Copyright © 2015, Juniper Networks, Inc.308
Network Interfaces for EX4300 Switches

Juniper EX3300 Specifications

General

Ethernet LAN	Yes
Authentication method	RADIUS, TACACS+
Connectivity technology	Wired
Ethernet interface type	Gigabit Ethernet
Number of VLANs	4096
Networking standards	IEEE 802.1ab, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ad, IEEE 802.3x, IEEE 802.3z
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Copper ethernet cabling technology	1000BASE-T, 100BASE-TX, 10BASE-T
Console port	-
ExpressCard slot	No
Fiber ports quantity	4
USB 2.0 ports quantity	0
Basic switching RJ-45 Ethernet ports quantity	48
Throughput	130 Mpps
Number of queues	8
MAC address table	16000 entries
Maximum data transfer rate	176 Gbit/s
Supported data transfer rates	10, 100, 1000Mbps
Switch type	Managed
Switch layer	L2
Security algorithms	SSH-2
Power source	AC
AC input voltage	100 - 240 V
Power consumption (typical)	100 W
Form factor	1U
Product color	Black
Flash memory	1024 MB
Processor frequency	1000 MHz
Compatible operating systems	Junos
Operating altitude	0 - 3049 m
Non-operating altitude	0 - 4877 m
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	10 - 85 %
Supported network protocols	IPv6

Weight and Dimensions

Depth	310 mm
Width	437 mm
Height	44 mm
Weight	4900 g