loose;
}
}
}
family iso {
address interface-address;
mtu bytes;
}
input-vlan-map action;
interface-shared-with psdnumerical-index;
output-vlan-map action;
proxy-arp (restricted | unrestricted);
swap-by-poppush;
(traps | no-traps);
vlan-id (VLAN Tagging and Layer 3 Subinterfaces) vlan-id-number;
vlan-id-list [vlan-id vlan-id–vlan-id];
}
vlan-tagging;
}
}
Unsupported Statements in the [edit interfaces xe] Hierarchy Level
All statements in the [edit interfaces xe] hierarchy level that are displayed in the
command-line interface (CLI) on the switch are supported on the switch and operate
as documented with the following exceptions:
Table 39: Unsupported [edit interfaces xe] Configuration Statements for EX Series Switches
HierarchyStatement
[edit interfaces xe]clocking
[edit interfaces xe]framing
[edit interfaces xe]passive-monitor-mode
[edit interfaces xe]stacked-vlan-tagging
[edit interfaces xe ether-options]asynchronous-notification
[edit interfaces xe ether-options]ignore-l3-incompletes
[edit interfaces xe ether-options]mpls
[edit interfaces xe ether-options]source-address-filter
[edit interfaces xe ether-options]source-filtering
[edit interfaces xe ether-options]no-source-filtering
[edit interfaces xe unit]accept-source-mac
151Copyright © 2015, Juniper Networks, Inc.
Chapter 3: Configuration Statements