Juniper SRX320

WARNING: Do not press the Power button while the device is shutting down.
CAUTION: Forced shutdown can result in data loss and corruption of the file
system.
NOTE: To remove power completely from the device, unplug the power cord
or switch off the AC power source.
After powering off a power supply, wait at least 10 seconds before turning it
back on. After powering on a power supply, wait at least 10 seconds before
turning it off.
The power button on the services gateway is a standby power switch, which
will not turn off the input power to the services gateway.
TIP: When you are powering off the device, the CLI displays the following
message: Turning the system power off. You can now safely remove the power
cable to completely power off the device.
NOTE: You can use the request system reboot CLI command to schedule a
reboot.
Related
Documentation
• Understanding the SRX320 Services Gateway Power Supply on page 15
• Powering On the SRX320 Services Gateway on page 68
69Copyright © 2016, Juniper Networks, Inc.
Chapter 17: Providing Power to the SRX320 Services Gateway