Synchronizing Time Code
on Another Camera
This
camera recorder is equipped with a time code
input/output terminal ([TC] terminal).
Connect another camera recorder to the [TC]
terminal and synchronize to the time code.
1
Connect the [TC] terminal of the master
device with the
[TC] terminal of the slave
device.
Set the [TC IN/OUT] switch of the master device
to “OUT”, and the [TC IN/OUT] switch of the
slave device to “IN”.
.
[IN]
Slave Device (This Camera Recorder)
[OUT]
Master Device
Settings and Operation of the Camera
Recorder
1
Set to Camera mode.
(A P
24 [Operation Modes] )
2
Set [TC/UB] B [TC Generator
] as follows.
0
Slave device:
Select “Free Run (Ext)”.
0
Master device:
Select
“Free Run”.
3
Set LCD monitor or viewfinder to Display
screen.
4
Set the master device and run the time
code.
0
When the built-in time code generator is
synchronized with the external time code
data
input, the Z icon on Display screen lights
up.
0
When time code is not synchronized or time
code input is not available, the Z icon goes
out.
.
1
/60
F2.8
AE
±0
ND1
/64
12 :34 :56
ISO
102400
00: 00:00.00
5 . 6 f t
B 5600
K
4030 20 10 0
Memo :
0
The built-in time code generator will continue
operation even when the master device is
disconnected after synchronization.
0
User’s
bit will become data in the master device.
Synchronizing Time Code on Another Camera
81
Shooting
To Next Page
Loading...
