9
Aspect Ratio
For
selecting the final image aspect ratio to be used
from the overall angle of view.
[Setting Values: 16:9(+4:3), 2.35:1 Top, 2.35:1
Center, 1.85:1 Top, 1.85:1 Center, R16:9, 1.75:1,
1.66:1, 14:9, 13:9, 4:3]
Memo :
0
When [System] B [Record Set
] B [Record
Format] B [SD Aspect] is set to “4:3”, this item
is fixed at “4:3” and cannot be selected.
(A P
159 [ SD Aspect ] )
9
Aspect Marker
For specifying how boundary markers are to be
used to indicate the parts of an image that are
beyond the range of the aspect ratio selected in
[Aspect Ratio].
0
Line+Halftone:
Displays the boundary using lines, and areas
outside the boundary in halftone.
0
Halftone:
Displays
areas outside the boundary in halftone.
0
Line:
Displays the boundary using lines.
0
Off:
Hides the boundary markers.
[Setting Values: Line+Halftone, Halftone, Line,
ROff]
Memo :
0
When [Aspect Ratio] is set to
“16:9” or
“16:9(+4:3)”, this item is fixed at “Off” and cannot
be selected.
9
Safety Zone
For setting the percentage of area that is to be
deemed as valid area (Safety Zone) within the
boundary of the aspect ratio selected in
[Aspect
Ratio].
[Setting Values: 95%, 93%, 90%, 88%, 80%, ROff]
9
Center Mark
For
specifying whether to display a mark to indicate
the screen center within the aspect ratio selected
in [Aspect Ratio].
[Setting Values: ROn, Off]
Display Type Item
This menu is used to set the displays on the LCD
monitor and viewfinder screen.
Battery
For setting the display of the remaining battery
power on the LCD monitor and viewfinder screen.
0
Time:
Displays the remaining battery power in
minutes. (min)
0
Capacity%:
Displays the remaining battery power in
percentage. (%)
0
Voltage:
Displays the current battery voltage in units of
0.1 V. (V)
[Setting Values: RTime, Capacity%, Voltage]
Memo :
0
The battery mark that appears before the “Time”,
“Capacity%” or “Voltage” value changes according to
the remaining battery power.
In addition, the plug mark is added during charging.
4
S
:
10 % and below
D
R
:
11 % to 30 %
C
Q
:
31% to 70 %
B
P
:
71 % to 100 %
0
When the remaining battery power is low, “RES”
instead of the value is displayed.
Replace the battery as soon as possible.
0
The remaining battery power and remaining time are
intended as reference values for the shooting
duration.
0
The time, capacity or voltage will not be displayed
during charging.
TC/UB
For specifying whether to display the time code
(TC)
or user’s bit (UB) rate in the display on the LCD
monitor and viewfinder screen.
[Setting Values: UB, RTC]
Zoom
For setting the display method of the zoom
position.
0
Number:
Displays the zoom position in numbers.
0
Bar:
Displays the zoom position in a bar.
[Setting Values: Number, RBar]
130
LCD/VF Menu
Menu Display and Detailed Settings
To Next Page
Loading...
Need help?
General
