79
Faults
Dismantling and Disposal
10 Dismantling and Disposal
After the unit has come to the end of its service life, it must
be dismantled and disposed of in an environmentally friendly
manner.
WARNING!
Risk of injury due to improper dismantling!
Stored residual energy, angular components,
points and edges on and in the unit or on the tool
required can cause injury.
– Make sure that you have enough space before
starting work.
– Handle open sharp-edged components carefully.
– Make sure that the workplace is clean and tidy
Components and tools stacked loosely or spread
around tools represent a source of accidents.
– Dismantle the components carefully. Note the
heavy net weight of some components. Use
lifting gear if necessary.
– Secure components to ensure that they do not
fall or topple.
– Contact the manufacturer if in doubt.
10.2 Dismantling
Beforecommencing:
Switch off the unit and prevent it from being switched on
again accidentally.
Physically disconnect the entire power supply from the unit
and discharge residual energy.
Remove operating and auxiliary materials and dispose of
properly.
Then clean assemblies and components properly and dismantle
in compliance with applicable local safety and environmental
regulations.
10.1 Safety Information for Dismantling and Disposal
Incorrect Dismantling
To Next Page
Loading...
