KaVo OP 3D Pro - 2.10 Warnings and precautions

2 Introduction
FH = Frankfort-Horizontal
H = Horizontal
ADC = Automatic Dose Control
LDT = Low Dose Technology
™
MAR = Metal Artifact Reduction
2.8 Signal words
The following signal words and labels are used in this document:
WARNING! Indicates a hazardous situation which, if not avoided, could result in
death or serious injury.
CAUTION! Indicates a hazardous situation which, if not avoided, could result in
minor or moderate injury.
NOTICE! Highlights suggestions which will result in enhanced installation,
reliability, or operation. Not used for safety related hazards.
2.9 Disposal
The device, its spare parts, its replacement parts and its accessories may include
parts that are made of or include materials that are non-environmentally friendly or
hazardous. These parts must be disposed of in accordance with all local, national and
international regulations regarding the disposal of non-environmentally friendly or
hazardous materials.
Unit has at least the following parts that should be regarded as non-environmental
friendly waste products:
● Tubehead (Pb, oil)
● Collimator (Pb)
● All electronic circuits, electronic boards inside
● Sensor covers (EMC painted)
2.10 Warnings and precautions
2.10.1 Warnings to be observed during use
● The unit may be dangerous to the user and the patient, if the safety regulations in
this manual are ignored, if the unit is not used in the way described in this manual
and/or if the user does not know how to use the unit.
● The unit must only be used to take the dental x-ray exposures described in this
manual. The unit must NOT be used to take any other x-ray exposures. It is not safe
to use the unit to take x-ray exposures, that it is not designed for.
● Only professionally qualified dental and/or medical personnel are allowed to operate
the unit and carry out any diagnoses based on output from the unit.
● Because the x-ray limitations and safety regulations change from time to time, it is
the responsibility of the user to make sure that all the valid safety regulations are
fulfilled.
ORTHOPANTOMOGRAPH
™
OP 3D Pro 9