6 Installation of the imaging plate system
44 KaVo Scan eXam One
Insert the software installation media (DVD) and
launch the software installer if it does not start
automatically.
Read the software installation manual. Follow the
instructions of the installation wizard to complete
the software installation. Refer the software
installation manual for details.
6.4 Accessing the unit from
CLINIVIEW
In order to operate the scanner unit from a
workstation the software needs to access the
desired scanner unit in the network. There can be
multiple scanners in one network. When using
multiple scanners each unit can be assigned a
unique call name by the user to separate the
scanners in the network. By default the name of
the scanner unit is “Scan eXam™ One”.
There are multiple ways of configuring the
connection between the scanner unit and the
operators software. The automatic connection is
based on automatically detecting the scanner in the
network. This is a preferred method.
6.4.1 Direct connection method (uses
the unit s/n)
NOTICE! It may not be possible to connect the unit
to the workstation using the direct connection
method if another device is al ready connected to
the workstation using direct connection. If the
direct connection field is not active (greyed out) or
the system does not work correctly after the unit
has been connected, reconnect the unit using the
imaging plate connection method.
1. After positioning the unit connect it to the work-
station(s) in the local area network using the
Ethernet cable (not included in delivery).
2. Switch the unit on. The imaging application soft-
ware symbol appears in the unit user interface.
This indicates that the unit is not communicating
with the workstation(s) in the network.
3. Workstation: Install the imaging application
software to be used in the workstation(s).
To Next Page
Loading...
Need help?
General
