Kaye RF ValProbe - Page 38

Chapter 2. Installing and Using RF ValProbe Software
RF ValProbe® User’s Manual 31
2.5.2 Creating Operator Accounts (cont.)
5. Enter the password again in the Reenter Password field.
At this point you should record the new user ID and password. You will need to
supply this information to each new user. A user ID/password combination is required
any time a user:
• Programs and/or reads Loggers
• Verifies sensor calibration
• Creates reports
• Moves or copies data files
• Changes preferences (if the System Administrator has enabled the Allow Operators
to change Preferences site option)
6. Click
Operator to set the account’s permission level.
7. The
Disable User Account option allows you to deny access to the system for this user.
For example, if you are creating an account for a user who will not need access to the
system for several months, you may want to select this option to deny access to the
user. You can de-select this feature once the user is ready to use the system (see the
Kaye RF ValProbe online Help for instructions on editing user accounts).
Select this option if you want to disable the user account.
8. Click
OK.
The
Password Maintenance screen (Figure 12 on the next page) appears with the
newly added user name in the active user list.