Chapter 2. Installing and Using RF ValProbe Software
34 RF ValProbe® User’s Manual
2.5.4 Selecting Site Options (cont.)
As the System Administrator, you can select options that will:
• Disable the user identification requirement.
IMPORTANT: If you disable the user identification requirement, the Kaye RF ValProbe
system does not meet FDA regulations for electronic signatures (21 CFR
Part 11).Kaye recommends that you always require user identification.
• Set passwords to expire after a number of days, up to 366. The user will be prompted
to change their password once their current password has expired. By default,
passwords are set to expire after 180 days.
• Require minimum-length passwords for all user accounts, from 1 to 16 characters.
• Disable user accounts after three unsuccessful login attempts. This option will disable
a user account if there are three consecutive login failures for the same user ID. If a
user's account is disabled, the System Administrator must enable the account and
assign a new temporary password.
• Allow Operators to change Preferences. Preferences are system defaults that specify
the temperature units, the communications port, the network ID, and when to issue
low battery warnings. Any changes made to the system preferences are effective
immediately, and all setups created after the preferences have been changed will
reflect these new settings. If this option is not enabled, the System Administrator is
responsible for changing preferences.
To Next Page
Loading...