KBR multicomp D6 7 Series - Relay Output Module Multisio D2 4 RO; Connection Diagram for Relay Output Module; Relay Output Module LED Display

V7.00
24905_EDEBDA0272-5019-1_EN
121
Appendix - multisio D2 4RO
8.2 Relay output module multisio D2 4RO
8.2.1 Connection diagram for relay output module
Terminal assignment:
Terminal 40: Shared connection (C)
Terminal 41: Output relay 1 ( K1 )
Terminal 42: Output relay 2 ( K2 )
Terminal 43: Output relay 3 ( K3 )
Terminal 44: Output relay 4 ( K4 )
IN/OUT:
Module bus/power supply
The LEDs represent:
LED1 for: Output relay 1 (K1) switched
LED2 for: Output relay 2 (K2) switched
LED3 for: Output relay 3 (K3) switched
LED4 for: Output relay 4 (K4) switched
Power LED: Operating voltage
8.2.3 Relay output module LED display
The LEDs on the relay output module indicate the current state of
the relay output. If the output is active, the LED is on.
If the output is passive, the LED is o.
In KBR eBus scan mode, all four output LEDs ash.
In module detection mode, the output LEDs generate
a chase light eect.