KBR multicomp D6 7 Series - Function of Scan Button; DIP Switch Functions

V7.00
24905_EDEBDA0272-5019-1_EN
122
multisio D24RO - Appendix
8.2.4 Function of Scan button
8.2.5 DIP switch functions
NOTE
If the scan button is pressed briey, the module
enters scanning mode.
Switch setting illustrated
OFF = white
ON = gray
The DIP switches do not function when in oper-
ation on the multicomp D6-xxx-7
Module-specic technical data:
Hardware outputs:
5-pole plug terminal
Supply voltage
for the relay outputs:
Terminal 40 Non-oating
4 relay outputs Terminals 41 to 44 Non-oating
Contact capacity 500 VA each,
2 A, 250 V and 50/60 Hz
Overvoltage category CAT II
Display LED 4x message
1x operation display
Control unit DIP switch 1x eightfold
Button Scan button (module bus)