KBR multicomp D6 7 Series - Analog Input Module LED Display

V7.00
24905_EDEBDA0272-5019-1_EN
140
9.2 Analog input module LED display
In KBR module bus scanning mode, all 4 input LEDs ash. In the module detection mode,
the input LEDs generate a chase light eect.
The LEDs represent:
LED1 for input 1
LED2 for input 2
LED3 for input 3
LED4 for input 4
Power LED on: Operating voltage is applied
The LEDs on the module with 4 digital inputs turn on when an analog input signal is
detected and the measured values are within the set limits. The LEDs go out if no analog
encoder is connected or if the encoder is short-circuited. The LEDs ash if the value
exceeds or falls below a limit.
NOTE
For operation at the multicomp D6-xxx-7 base device, the module is always set up for
0–20mA/0–10V, meaning that the LEDs of inputs 1–4 are always on.
The conversion 4–20mA/2–10V takes place in the base device.
Appendix – multisio D2-4AI analog input module