KBR multicomp D6 7 Series - Technical Data

V7.00
24905_EDEBDA0272-5019-1_EN
126
multisio D2 4RO accordance with ISO - Appendix
DIP operating
mode
State DIP Explanation
S5
O — — Output 1 = normal operating mode
On S1
O Output 1 = manual operating mode passive / o
On Output 1 = manual operating mode passive / o
S6
O — — Output 2 = normal operating mode
On S2
O Output 2 = manual operating mode passive / o
On Output 2 = manual operating mode passive / o
S7
O — — Output 3 = normal operating mode
On S3
O Output 3 = manual operating mode passive / o
On Output 3 = manual operating mode passive / o
S8
O — — Output 4 = normal operating mode
On S4
O Output 4 = manual operating mode passive / o
On Output 4 = manual operating mode passive / o
8.3.4.3 Technical data
Power supply: Via module bus 24VDC / ca. 1.3W
Connection RJ-12:6P6C
modular connector
Hardware outputs: 4 plug terminal, each 2 pole
4 relay outputs Terminals 40 to 47 oating
Contact capacity 500VA each, 2A, 250V and
50/60Hz
Overvoltage category CAT II
Module bus
interface:
Serial interface RS-485
Module bus connection RJ-12 for ready-made KBR sys-
tem cable, max. length 30m
when suitably placed
Transmission speed 38400 Bps
Bus protocol KBR module bus