KBR multicomp D6 7 Series - Digital Input Module LED Display; Function of Scan Button

V7.00
24905_EDEBDA0272-5019-1_EN
145
10.2 Digital input module LED display
In KBR module bus scanning mode, all 4 input LEDs ash. In the module detection mode,
the input LEDs generate a chase light eect.
The LEDs represent:
LED1 for input 1
LED2 for input 2
LED3 for input 3
LED1 for input 4
Power LED on: Operating voltage is applied
The LEDs on the digital input module indicate the current state of the digital input. If the
input is active, the LED is on. If the input is passive, the LED is o.
10.3 Function of Scan button
NOTE
If the scan button is pressed briey,
the module enters scanning mode.
Illustrated switch setting:
OFF = white
ON = gray
Appendix – multisio D2-4DI digital input module