KBR multicomp D6 7 Series - Function of the DIP Switches; Operating Mode

V7.00
24905_EDEBDA0272-5019-1_EN
146
10.3 Function of the DIP switches
10.3.1 Operating mode
For every input, the multisio D2-4DI dierentiates
between the operating modes “normal” and “manual.” Switching
is performed via the DIP switches 5 to 8. The DIP switches
are assigned to the outputs as follows:
• DIP switch 5 switches the operating mode of input 1
• DIP switch 6 switches the operating mode of input 2
• DIP switch 7 switches the operating mode of input 3
• DIP switch 8 switches the operating mode of input 4
If the DIP switch is set to O, the respective input
is in normal operating mode. If the
DIP switch is set to On, the respective
input is in manual operating mode.
Illustrated switch setting:
OFF = white
ON = gray
Normal operating mode
In normal operating mode, the current state of the associated input is further processed.
Manual operating mode
In manual operating mode, the state of DIP switches 1 to 4 is further processed, instead
of the state of the corresponding input. The DIP switches are assigned to the inputs as
follows:
• DIP switch 1 switches the state of input 1
• DIP switch 2 switches the state of input 2
• DIP switch 3 switches the state of input 3
• DIP switch 4 switches the state of input 4
If the DIP switch is set to O, the input state passive/o is further processed. If the DIP
switch is set to On, the input state active/on is further processed.
Appendix – multisio D2-4DI digital input module