KBR multicomp D6 7 Series - 5.3 Device Configuration and Commissioning

V7.00
24905_EDEBDA0272-5019-1_EN
38
5.4 Device programming
The menu guidance of the multicomp D6-xxx-7 is self-explanatory.
The operator is guided and supported by the device through operating instructions dis-
played for the respective situation. The following terms are available for programming:
Para Return for conguration
EDIT Perform conguration
“ Submenu or parameter selection
 Value input
 Selection
YES Conrmation to save conguration
NO Discard conguration
¡ Return
This display is used for initial startup of the controller, where all necessary settings can
be made.
NOTE
These settings are described in detail under the
menu item Extras/Commissioning
5.5 Start menu Commissioning
If the multicomp D6-xxx-7 is being commissioned for the rst time, the menu Extra/
Commissioning is displayed as the start screen (after the initialization phase) after setting
up the multicomp D6-xxx-7 supply voltage:
System operation