KBR multicomp D6 7 Series - Temperature Module LED Display; Function of Scan Button

V7.00
24905_EDEBDA0272-5019-1_EN
129
The LEDs represent:
LED1 on: Alarm relay switched
(contact open)
LED2 on: Fan relay closed
LED3 on: Temperature probe not connected
LED4 on: Short circuit on temperature probe
Power LED: Operating voltage
8.4.2 Temperature module LED display
In KBR eBus scan mode, all four input LEDs ash. In the module detection mode, the input
LEDs generate a chase light eect.
8.4.3 Function of Scan button
NOTE
If the scan button is pressed briey, the module
enters scanning mode.
Switch setting illustrated
OFF = white
ON = gray
Appendix - multisio D2 4RO accordance with ISO