Keba D3-DA 3 Series - 6.7 Control connections

D3DA3xx/xConnectionsandwiring
ProjectengineeringmanualV1.00
58
©KEBA
6.6.3 Overviewofbusbars
Illustration635:Cover
1 ...Sidecover 2 ...Barrierstrip
DANGER!
Themultiaxissystemisonlyallowedtobeoperatedwiththecoveronthe
busbarsclosed!Itisalsoimportantthatthesidecovers(A)andthebarrier
strip(B)arefitted.Bothprovideprotectionagainstphysicalcontactwithbare
andliveparts.Deathorseriousinjuriesmayoccuriftheseprotectivemea
suresarenottaken.
6.7 Controlconnections
1) Checkwhetheracompletedevicesetupisalreadyavailable,i.e.whether
thedrivehasalreadybeenconfigured.
2) Ifthisisthecase,aspecialcontrolterminalassignmentapplies.
Pleasecontactyourprojectengineertoobtaintheterminalassignment!
3) Chooseaterminalassignment.
4) Leaveallcontactsopen(inputsinactive).
5) Checkallconnectionsagain!