I
*IDN? — identification query 8-3
IFC (interface clear) 6-4
Independent voltage measurements
(DVM) 2-13
Inspection 1-3
Integration time 4-3, 4-5
Integration times 3-3, 3-4
Introduction 6-2
L
Line power connection 1-6
LLO (local lockout) 6-5
Long integration measurement procedure 4-7
Long integration measurements 4-1
Long integration display mode 4-7
M
:MEASure:ARRay[:<function>]? 9-4
:MEASure[:<function>]? 9-4
Measurement configuration 2-11, 2-13, 3-4, 4-5
Menu 1-11
Message exchange protocol 6-12
O
*OPC — operation complete 8-3
*OPC? — operation complete query 8-3
Operate 2-8
Options and accessories 1-3
Output format 6-3
Output queue 7-17
Outputting and reading back V and I 2-15
Outputting voltage and current 2-3
Overview 3-2, 4-2, 5-2, 7-2, 8-2, 9-2
P
Power supply overview 1-4
Power-up 1-6
Power-up sequence 1-7
Primary address 6-3
Program messages 6-10
Programming and reading registers 7-5
Programming enable registers 7-5
Programming example 4-11
Programming examples 2-15, 3-10
Programming example — program and read
measurement event register 7-17
Programming syntax 6-7
Protocol differences (488.1) D-3
Pulse current display mode 3-5
Pulse current digitization 3-9
Pulse current measurement procedure 3-6
Pulse current measurements 3-1
Pulse timeout 4-4, 4-6
Q
Queues 7-2, 7-17
R
*RCL <NRf> — recall 8-4
:READ? 9-3
:READ:ARRay? 9-3
Reading back V and I 2-11
Reading registers 7-5
Register bit descriptions 7-10
Relay control 5-1
Remote display option 1-6
Remote indicator and local key 6-6
REN (remote enable) 6-4
Response messages 6-12
*RST — reset 8-4
Rules to navigate MENU 1-13
To Next Page
Loading...
