Keithley 2303

S
Safety symbols and terms 1-2
*SAV <NRf> — save 8-4
SCPI command subsystems reference
tables 11-2
SCPI programming 1-13, 3-7, 4-9, 5-5
SCPI programming — measure V and I, and
DVM input 2-12
SCPI programming — DVM 2-13
SCPI programming— outputting voltage and
current 2-8
SCPI tables 11-1
SDC (selective device clear) 6-5
Selecting the 488.1 protocol D-2
Serial polling and SRQ 7-8
Service request enable register 7-7
Setting output voltage and current limit 2-3
Setups — Save, Power-on, and Recall 1-10
Signal oriented measurement commands 9-1
Sink operation 2-14
SPE, SPD (serial polling) 6-5
Specifications 1-2, A-1
Status byte and service request (SRQ) 7-6
Status byte and service request commands 7-9
Status byte and SRQ 7-2
Status byte register 7-7
Status register sets 7-2, 7-10
Status structure 7-1
:SYSTem subsystem 10-7
:SYSTem:POSetup <name> 10-7
T
Test connections 2-2
*TRG — trigger 8-4
Trigger delay 3-3
Trigger delay and trigger level 3-5
Trigger edge 4-3
Trigger edge and trigger level 4-6
Trigger level 3-3, 4-3
*TST? — self-test query 8-5
W
*WAI — wait-to-continue 8-5
Warranty information 1-2