In this section:
About this section ................................................................... 11-1
Where can I find updated drivers? ......................................... 11-1
Is there any software to help me get started .......................... 11-2
How do I upgrade the firmware? ............................................ 11-2
Why can't the DAQ6510 read my USB flash drive? ............... 11-3
How do I change the command set? ...................................... 11-3
How do I save the present state of the instrument? ............... 11-4
Why did my settings change? ................................................ 11-5
What is the ethernet port number? ......................................... 11-5
About this section
This section helps you find answers to the most common questions encountered with the DAQ6510.
Where can I find updated drivers?
For the latest drivers and additional support information, see the Keithley Instruments support
website.
To see what drivers are available for your instrument:
1. Go to tek.com/keithley.
2. Enter the model number of your instrument.
3. Select Software Driver from the list.
If you use the native LabVIEW
TM
or IVI driver, you must configure the DAQ6510 to use the SCPI
command set. For information on changing the command set, refer to
How do I change the
command set? (on page 3-18)
Section 11
Troubleshooting/FAQ
To Next Page
Loading...
Need help?
General
