4: Making basic front-panel measurements DAQ6510 Data Acquisition / Multimeter System
4-2 DAQ6510-900-01Rev. A / April 2018
Device connections
Connect the DAQ6510 to the resistor in a 2-wire (local sense) configuration. In this configuration, the
device is connected between the INPUT HI and INPUT LO terminals.
To make the connections:
1. Power off the DAQ6510.
2. Connect the test leads to the front-panel INPUT HI and INPUT LO terminals, as shown in the
following figure.
3. Connect the test leads to the resistor.
Figure 29: DAQ6510 front-panel 2-wire resistance measurement
To Next Page
Loading...
