Data Acquisition / Multimeter System User's Manual Section 2: Front-
DAQ6510-900-01Rev. A / April 2018 2-3
SENSE terminals
Use the SENSE HI and SENSE LO terminals and the INPUT
terminals with the 4-wire resistance, 3-wire and 4-wire RTD
temperature, and DC voltage ratio functions.
Use the INPUT HI and INPUT LO terminals for all measurements
except current.
Use the AMPS connection with the INPUT LO terminal to
measure ≤3A DC or AC
RMS
current.
TERMINALS
switch
Activates the terminals on the front or rear panel. Selecting the
rear panel provides the proper connections to an inserted
moduleWhen the front-panel terminals are active, the green LED
is visible. When the rear-panel terminals are active, the amber
Instrument power
Follow the steps below to connect the DAQ6510 to line power and turn on the instrument. The
DAQ6510 operates from a line voltage of 100 V to 240 V at a frequency of 50 Hz or 60 Hz. Make sure
the operating voltage in your area is compatible. The default setting is 240V.
Before plugging in the line cord, check the line setting block on the rear of the instrument. If it doesn’t
match their mains installation setting, remove the block and reinsert to select voltage.
You must turn on the DAQ6510 and allow it to warm up for at least 30 minutes to achieve rated
accuracies.
Operating the instrument on an incorrect line voltage may cause damage to the instrument,
possibly voiding the warranty.
To Next Page
Loading...
Need help?
General
