Data Acquisition / Multimeter System User's Manual Section 11:
DAQ6510-900-01Rev. A / April 2018 11-5
Why did my settings change?
Many of the commands in the DAQ6510 are saved with the measure function that was active when
you set them. For example, assume you have the measure function set to current and you set a value
for display digits. When you change the measure function to voltage, the display digits value changes
to the value that was last set for the voltage measure function. When you return to the current
measure function, the display digits value returns to the value you set previously.
What is the ethernet port number?
The port number is 5025.
To Next Page
Loading...
