7-10 Range, Digits, Speed, and Filters 2400 Series SourceMeter
®
User’s Manual
Front panel filter control
Configuring filter
Filter type and count is configured from the CONFIGURE FILTERING menu and is struc-
tured as shown in Figure 7-3. Use Section 1, “Rules to navigate menus,” to check and/or
change the filter configuration.
CONFIGURE FILTERING menu
Press CONFIG and then FILTER to display the menu.
•AVERAGING MODE — Use this menu item to select filter type (MOVING or
REPEAT).
•AVERAGE COUNT — Use this menu item to specify filter count (1 to 100
readings).
NOTE The configured filter is the same for all measurement functions.
Enabling filter
The filter is enabled by pressing the FILTER key. The “Filter Enabled” message and the
filter count are briefly displayed. The FILT annunciator is on while the filter is enabled.
Pressing FILTER a second time disables filter.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
