2400 Series SourceMeter
®
User’s Manual SCPI Command Reference 18-19
Table 18-9
SYSTem command summary
Command Description
Default
parameter SCPI
Source
memory
:SYSTem
:PRESet Return to :SYSTem:PRESet defaults. ✓
:POSetup <name> Select power-on setup (RST, PRESet or
SAV 0-4).
:POSetup? Query power-on setup.
:VERSion? Query revision level of SCPI. ✓
:ERRor Path to read messages in error queue
(Note 1).
[:NEXT]? Return and clear oldest error (code and
message).
✓
:ALL? Return and clear all errors (codes and
messages).
:COUNt? Return the number of errors.
:CODE Path to return error code numbers only:
[:NEXT]? Return and clear oldest error (code
only).
:ALL? Return and clear all errors (codes only).
:CLEar Clears messages from error queue.
:RSENse <b> Enable or disable remote sensing. OFF ✓
:RSENse? Query state of remote sensing.
:KEY <n> Simulate key-press (1 to 31). See
Figure 18-3.
:KEY? Query the last pressed key. ✓
:GUARd <name> Select guard type (OHMS or CABLe). CABLe ✓
:GUARd? Query guard type.
:BEEPer Control beeper:
[:IMMediate]
<freq, time>
Beep at specified frequency (65 to 2e6 Hz)
for specified time period (0 to
7.9 seconds).
:STATe <b> Enable or disable beeper. ON
:STATe? Query state of beeper. ✓
1. Clearing Error Queue — Power-up and *CLS clears the error queue. *RST, :SYSTem:PRESet, and :STATus:PRESet have no effect.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
