18-2 SCPI Command Reference 2400 Series SourceMeter
®
User’s Manual
Reference tables
Table 18-1 through Table 18-11 summarize the commands for each SCPI subsystem. The
following list includes the SCPI subsystem, table number where each command is summa-
rized, and the page number where detailed reference information begins.
General notes:
• Brackets ([ ]) are used to denote optional character sets. These optional characters
do not have to be included in the program message. Do not use brackets in the pro-
gram message.
• Angle brackets (< >) are used to indicate parameter type. Do not use angle brackets
in the program message.
• The Boolean parameter (<b>) is used to enable or disable an instrument operation.
1 or ON enables the operation, and 0 or OFF disables the operation.
• Upper case characters indicate the short-form version for each command word.
• Default Parameter — Listed parameters are both the *RST and :SYSTem:PRESet
defaults, unless noted otherwise. Parameter notes are located at the end of each
table.
• SCPI — A checkmark (✓) indicates that the command and its parameters are SCPI
confirmed. An unmarked command indicates that it is a SCPI command, but does
not conform to the SCPI standard set of commands. It is not a recognized com-
mand by the SCPI consortium. SCPI confirmed commands that use one or more
non-SCPI parameters are explained by notes.
• Source Memory — A checkmark (✓) indicates that the parameters associated with
the specified command are saved in any one of 100 memory locations by the
:SOURce[1]:MEMory:SAVE command.
Summary table Subsystem Reference page
Table 18-1
Table 18-2
Table 18-3
Table 18-4
Table 18-5
Table 18-6
Table 18-7
Table 18-8
Table 18-9
Table 18-10
Table 18-11
CALCulate
DISPlay
FORMat
OUTPut
ROUTe
SENSe
SOURce
STATus
SYSTem
TRACe
TRIGger
page 18-24
page 18-46
page 18-49
page 18-57
page 18-59
page 18-60
page 18-72
page 18-104
page 18-106
page 18-117
page 18-120
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com