2400 Series SourceMeter
®
User’s Manual Getting Started 1-15
TOGGLE key
NOTE For the Model 2430 Pulse Mode, the TOGGLE key is disabled.
With the output on, the TOGGLE key manipulates readings on the top display and on the
bottom-left display. It has no effect on the compliance reading (Cmpl), which is located on
the bottom right. Each press of the TOGGLE key sequences through the display options.
With the voltage (V) or current (I) measurement function selected, the TOGGLE key lets
you display both the current and voltage measurements at the same time. It also allows
you to toggle display positions of the source and measure readings.
With the ohms (Ω) measurement function selected, the ohms measurement is always
displayed on the top display. The TOGGLE key lets you display either the programmed
source value, the current measurement, or the voltage measurement on the bottom-left
display.
The TOGGLE key is also used to display statistical data on readings stored in the data
store. This function is performed from the data store RECALL mode.
NOTE If FCTN, REL, or Limits is enabled, the TOGGLE key is disabled.
Status and error messages
Status and error messages are displayed momentarily. During SourceMeter operation and
programming, you will encounter a number of front panel messages. Typical messages are
either status or error in nature and are listed in Appendix B.
Remote display programming
The display can also be controlled by various SCPI :DISPlay subsystem commands. Table
1-3 summarizes basic commands. See Section 18, “DISPlay subsystem,” for more infor-
mation on using these commands. See also “Disabling front panel display,” page 1-25.
Table 1-3
Basic display commands
Command Description
:DISPplay:ENABle <state> Enable/disable display (state = ON or OFF).
:DISPlay:CNDisplay Return to source-measure display.
:DISPlay:DIGits <n> Set display resolution (n = 4 to 7).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
