NOTICE
The purchase of the KCAM© software grants the purchaser the license to use the software, not the ownership of the
KCAM© software.
This document may not be copied in whole or in part without the expressed written permission of Kern Electronics &
Lasers, Inc.
Although every effort has been made to assure that the information in this document is accurate and complete, Kern
Electronics & Lasers, Inc. shall not be liable for any direct, indirect, incidental, or consequential damages resulting from
any deficiencies in this document. All information in this document is subject to change without notice.
Kern Electronics & Lasers, Inc. makes no warranty as to the usefulness of its products for any particular application. It is
the Buyer’s responsibility to develop processes within the operating envelope of Kern products.
The user must understand the hazards of motion control systems and lasers before operating the software and hardware.
Kern Electronics & Lasers, Inc. will not assume responsibility for failure to operate the Kern Laser System automated
equipment in a safe manner. If you, the customer, have questions about operating a Kern Laser System, please call the
factory for written assistance.
To Next Page
Loading...
General