KERN DHS User Manual

Activate on "Enter Key": Allows cutting and engraving to start by pressing Enter key.
Manual: Opens the Manual Test screen. This screen allows you to manually fire the laser and run
the motion of the laser system.
Table Map: Mapping program to increase table accuracy. These settings are preset and should not
be adjusted without the help of a Kern support technician.
Tcp Control: Used for Kern technician troubleshooting.
Debug/Scope Windows: Used for Kern technician troubleshooting.
Help
KCAM7 Help Contents: Brings you to the top of the Help page.
Online Help: Sends you to the Kern Technical Support page.
About KCAM 7: Displays details on the version of KCAM you are running.
Setup Icon
Vector Colors Tab
The Vector Colors tab is where you set cutting power levels, speeds, modulation mode and to
enable/disable up to 9 different colors of vector lines.
Vector Colors
Enable (Colors)
The checkboxes to the left of the colors list will enable or disable its corresponding vector line color.
All/None: Allows you to quickly enable or disable all colors.
25

KERN DHS Specifications

General

Brand	KERN
Model	DHS
Category	Cutter
Language	English