Tcp control interface
For k-vision. Call Kern factory for correct settings.
Controller
Controller: Parallel or USB
Controller Port: Set to 378 if using Parallel Port.
Note command line
Directory for note pad.
TCP XPS Printer Server
Call Kern factory for correct settings.
Cut Icon
This screen allows you to start the cutting and/or engraving of a file.
Cut and Engrave Menu
Array Status
Enable: When checked, this will create an array if you have enabled and set distances in the Misc
Settings tab under the Setup button. The X and Y boxes allow you to run a file from the beginning,
or skip certain rows and columns to start at a different arrayed part.
39
To Next Page
Loading...
General