Repeat
Enable: When checked the laser will pause when finished with a file. By pressing the Enter key you
can start the file over again. The pause can be removed under the Setup button, Misc settings tab,
Automation section.
Align each time: When checked, the system will go to the home position and align the table before
repeating the file again.
Use Counter: Sets a count of how many repeats of the file you want to process.
Settings
Cut vector files: Check to cut a vector file.
Engrave image files: Check to engrave a raster file.
Check both boxes for a cut and engrave combination. Laser will engrave first, then cut.
“Soft Home” at end: By checking this you are enabling the new home position, set at Misc Settings
in the Setup Menu.
Enable Height Follower: Enables or disables Height Follower feature.
Action
Start/Continue (Enter) (F9): Starts or resumes the cutting or engraving of the file.
Pause: Pauses motion immediately (Hard Pause). Use mouse to click or press ESC key.
Air On/Off: Turns optics air on to test for proper setting.
Height Follower Up/Down: Moves height follower head down to set proper gap from nozzle to
metal part.
Go Home: Drives to the Home position.
Soft Home: Drives to the Soft Home position.
Align: Table returns to the Home position and presses the limit switches.
Pause at end of line: Pauses at the end of the line it is currently on (Soft Pause).
Pause at next part: Finishes current vector line or part then pauses.
Manual: Opens the Test Screen
Position in File
The display window shows what line of the file you are on. By editing the Line box you can skip
ahead or move back to any line in the file.
Set to start: Starts cutting or engraving at beginning of the file.
Line: Starts cutting or engraving at beginning of previous/next line.
File: Starts cutting or engraving at the beginning of previous/next file.
Back to pause: Resumes cutting or engraving where last paused.
40
To Next Page
Loading...