Need help?Do you have a question about the KERN DHS and is the answer not in the manual?
Describes essential safety guidelines for operating the laser system.
Details federal regulations and compliance procedures for laser products.
Lists minimum computer, software, and air supply requirements.
Overview of DHS machine components and its application.
Steps for uncrating, moving, and leveling the laser system.
Procedures for setting up cooling and gas supply systems.
Guidelines for aligning optics and installing the height follower.
Steps for starting the laser system daily.
Instructions for creating cutting and engraving files.
Procedures for aligning mirrors and focusing optics.
Ensuring table accuracy and setting origin points.
Steps to align engraving dots for precision.
Introduction to KCAM interface and initial setup.
Configuring cutting parameters by color.
Adjusting power, speed, and scanning for engraving.
Configuring motor speeds and fine-tuning for engraving.
Using the Cut Icon and related functions.
Steps for focusing optics for metal cutting.
Detailed process for cutting metal materials.
Introduction to k-vision and camera settings.
Calibrating the vision system and performing cuts.
Installing the rotary attachment and configuring software.
Setting up CorelDRAW and creating cut/engrave files.
Settings for printing from AutoCAD to the laser system.
Steps for installing and using PhotoGrav for photo engraving.
Routine maintenance schedules for the laser system.
Procedures for cleaning mirrors and lenses.
Understanding KLMC lights and basic troubleshooting.
Diagnosing and resolving problems with system movement.
Verifying laser firing requirements and power.
Visual representations of key system components.
Diagrams for additional system components.
Details on in and out of warranty service.
To Next Page
General