Keysight Technologies Z Series User Manual

20 Infiniium Z-Series Oscilloscopes User’s Guide
1 Setting Up the Oscilloscope
Turning On the Oscilloscope
1 Press the power switch in the lower left corner of the oscilloscope front panel.
After a short initialization period, the oscilloscope display appears. The
oscilloscope is ready to use.
2 You can connect and disconnect probes and cables while the oscilloscope is
turned on.
1R 3R
Aux
Run Control
Horizontal
Level
Trigger
Measure
Vertical
Position Touch Turn
Aux Out Cal Out
for Vernier
Push
Push
to Zero
Push
for Vernier
Push
to Zero
Push
(Push for 50%)
for Vernier
(Push to Toggle)
(Hold to Reset)
to Zero
Push
Menu
Source
Slope Sweep
Auto
Scale
Default
Setup
Clear
Display
Multi
Purpose
1
2
3
4
Run
Stop
Single
Print
Screen
Zoom
Touch
Short
Cut
Markers
RealEdge
Digital Storage OscilloscopeDSO-X 96204Q 160 GSa/s62 GHz
Power switch
Digital Storage OscilloscopeDigital Storage OscilloscopeDSO-Z 204ADSO-Z 204A 80 GSa/s80 GSa/s20 GHz 20 GHz
Z-SeriesZ-Series
Figure 5 Turning On the Oscilloscope

Keysight Technologies Z Series Specifications

General

Brand	Keysight Technologies
Model	Z Series
Category	Test Equipment
Language	English