52 Infiniium Z-Series Oscilloscopes User’s Guide
2 Using the Oscilloscope
Forcing a Default Setup
If your Infiniium oscilloscope is not working properly when you start it up, follow
these steps to perform a default setup and return the Infiniium to normal
operation.
1 Click Control > Default Setup or press the [Default Setup] key.
2 If the oscilloscope is still not working properly, click Control > Factory Default to
return the oscilloscope to the default settings it had when it left the factory.
3 If the oscilloscope is still not working properly, turn it off.
4 Turn the oscilloscope back on. If it does not successfully restart, try recycling
the power again.
5 As soon as the Windows 7 load screen disappears, press [Default Setup]. If the
oscilloscope still does not successfully restart, follow the instructions for
recovering the hard drive.
Infiniium hard drive recovery
Follow these steps to recover your Infiniium hard drive.
1 Turn off the oscilloscope.
2 Connect the keyboard to the keyboard connector on the rear panel of the
oscilloscope.
3 Connect the mouse to the mouse connector on the rear panel of the
oscilloscope.
4 Turn on the oscilloscope.
5 As soon as you see the message press F2 to boot the Infiniium Recovery
System, press F2 and follow the on-screen instructions.
6 Once the recovery process is finished and the oscilloscope is running, check in
the About Infiniium dialog box under installed options to see if all of the options
you ordered are installed. If the options are not installed, please install them
using the license keys provided on the oscilloscope option license certificates
you received, or refer to the rear panel of the oscilloscope.
To Next Page
Loading...
Need help?
General
