57
Keysight Infiniium Z-Series Oscilloscopes
User’s Guide
A Safety Information
English
The following general safety precautions must be observed during all phases of operation
of this instrument. Failure to comply with these precautions or with specific warnings or
operating instructions in the product manuals violates safety standards of design,
manufacture, and intended use of the instrument. Keysight Technologies assumes no
liability for the customer's failure to comply with these requirements. Product manuals are
provided with your instrument on CD-ROM and/or in printed form. Printed manuals are an
option for many products. Manuals may also be available on the Web. Go to
www.keysight.com and type in your product number in the Search field at the top of the
page.
General Do not use this product in any manner not specified by the manufacturer. The protective
features of this product may be impaired if it is used in a manner not specified in the
operation instructions.
Before Applying
Power
Verify that all safety precautions are taken. Make all connections to the unit before
applying power. Note the instrument's external markings described in “Safety Symbols”.
Ground the
Instrument
If your product is provided with a grounding type power plug, the instrument chassis and
cover must be connected to an electrical ground to minimize shock hazard. The ground pin
must be firmly connected to an electrical ground (safety ground) terminal at the power
outlet. Any interruption of the protective (grounding) conductor or disconnection of the
protective earth terminal will cause a potential shock hazard that could result in personal
injury.
Fuses See the user's guide or operator's manual for information about line-fuse replacement.
Some instruments contain an internal fuse, which is not user accessible.
Do Not Operate in an
Explosive
Atmosphere
Do not operate the instrument in the presence of flammable gases or fumes.
Do Not Remove the
Instrument Cover
Only qualified, service-trained personnel who are aware of the hazards involved should
remove instrument covers. Always disconnect the power cable and any external circuits
before removing the instrument cover.
Cleaning Clean the outside of the instrument with a soft, lint-free, slightly dampened cloth. Do not
use detergent or chemical solvents.
To Next Page
Loading...
Need help?
General
